Cruise-Control Module (C-CM): Installation

1.

If required, install the 3 bolts and the C-CM bracket assembly.
1. 1.
  
  Tighten the bolts to 8 Nm (71 lb-in).

NOTE: If a plastic grommet breaks while the C-CM is being installed, a new grommet should be installed.

2.
Firmly apply pressure to the C-CM so that it seats completely in the grommets.

3.

Once the C-CM is installed, pull the C-CM to confirm that all 3 ball studs are fully seated in the grommets.
1. 1.
  
  Connect the electrical connector.

4.

Check the C-CM alignment. Refer to Cruise Control Module (C-CM) (with Sensor) Adjustment .

5.

If a new module is installed, download the module information from the scan tool to the new C-CM by following the scan tool on-screen instructions.

6.

If a new module is installed, it must be reconfigured using PMI. REFER to Module Configuration .

7.

Install the front bumper cover. REFER to Bumpers .