Power-Fold Seat Module (PFSM): Removal
NOTE:
For component identification and locations, Refer to Seat - Exploded View .
- 1.
Position the LH seat to the load floor position.
NOTE:
If power seat is inoperative, Refer to Manual Override of Inoperative Power Seat - 3rd Row .
- 2.
Separate the LH load floor support from the load floor panel.- Push the load floor support rearward and slightly lift the load floor to disengage.
NOTE:
Do not lift the load floor flapper panel too far or damage to the wire harness retainers will occur.
- 3.
Slightly raise the LH load floor flapper panel, pull up and detach the wire harness retainer attached to the load floor support studs.
- 4.
Carefully lift the LH load floor flapper panel, disconnect the electrical connectors, detach the retainers and remove the PFSM.
