PINPOINT TEST G : The Rain Sensitive Wipers Are Inoperative: Notes
Refer to WIPERS SYSTEM AND WASHERS SYSTEM for schematic and connector information.
Normal Operation and Fault Conditions
Refer to Wipers and Washers - Front .
When an inoperative condition exists in the rain sensitive wiper system (or if the rain sensitive wiper feature is not enabled through the message center), the rain sensitive wiper system defaults to the normal intermittent (dwell time) settings.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B10AD:02 | Rain Sensor: General Signal Failure | This DTC sets when the SCCM determines a general signal failure has occurred on the LIN. |
| B10AD:08 | Rain Sensor: Bus Signal / Message Failure | This DTC sets when the SCCM determines a communication error has occurred on the LIN. If the rain sensitive wipers are inoperative only, this DTC may be caused by an open in the rain sensor power or ground circuit or an open in the LIN circuit. |